• Welcome to BellGab.com Archive.
 

Random stupid things on your mind. Post them.

Started by timpate, September 20, 2010, 07:56:24 PM

Quote from: PB the Deplorable on April 27, 2018, 10:58:11 PM
Could always be worse, could have been John Hogue



No Tarpley or Hogue in Episode 2 so far, but Nusbacher has shown up.  What an acid trip this show is.



Was researching some stuff and came across this magazine cover.  I'm not sure what the hell State had to do with Madame Nhu?


Dr. MD MD

Quote from: Walks_At_Night on April 28, 2018, 06:52:45 PM
Was researching some stuff and came across this magazine cover.  I'm not sure what the hell State had to do with Madame Nhu?



Keep researching it. You will. ;)


Dr. MD MD

Quote from: Walks_At_Night on April 28, 2018, 07:06:32 PM
If I can get past Madam's bazongaa's   Who knew?

Asian chicks are hot! Go rub one out and then research it. ;)

Quote from: Dr. MD MD on April 28, 2018, 07:07:27 PM
Asian chicks are hot! Go rub one out and then research it. ;)

Yes, Asian women can be quite attractive.  I even married one.

About to follow this guys advice on my garage door - hopefully he knows what the hell he is talking about!



https://www.youtube.com/watch?v=KiZvXfMCmgs

GravitySucks

Quote from: Walks_At_Night on April 29, 2018, 11:16:00 AM
About to follow this guys advice on my garage door - hopefully he knows what the hell he is talking about!



https://www.youtube.com/watch?v=KiZvXfMCmgs

Pretty dangerous but I didn’t watch the video. I just remember being scared the whole time

GravitySucks

Quote from: GravitySucks on April 29, 2018, 11:23:36 AM
Pretty dangerous but I didn’t watch the video. I just remember being scared the whole time

Mine is 3 times that wide and two foot taller though. Much heavier spring.

Quote from: GravitySucks on April 29, 2018, 11:23:36 AM
Pretty dangerous but I didn’t watch the video. I just remember being scared the whole time

I haven't told Mrs. Walks how dangerous it is..........   Well - I'm going in!

starramus

Quote from: Dr. MD MD on April 28, 2018, 07:07:27 PM
Asian chicks are hot! Go rub one out and then research it. ;)

That's called a trade in. You "trade in" your barren middle aged unattractive model for a beautiful young fertile model that will allow you to replicate your genotype. The only "immortality" available to us.

ShayP

Quote from: GravitySucks on April 29, 2018, 11:25:33 AM
Mine is 3 times that wide and two foot taller though. Much heavier spring.

Well, everything is bigger in Texas.  :D

Dr. MD MD

Quote from: starramus on April 29, 2018, 11:32:40 AM
That's called a trade in. You "trade in" your barren middle aged unattractive model for a beautiful young fertile model that will allow you to replicate your genotype. The only "immortality" available to us.

From jerking off?! ???

GravitySucks

Quote from: ShayP on April 29, 2018, 11:33:08 AM
Well, everything is bigger in Texas.  :D

Fuckin A right peckerhead and don’t you go forgettin it neither.

Dr. MD MD

Quote from: GravitySucks on April 29, 2018, 11:37:25 AM
Fuckin A right peckerhead and don’t you go forgettin it neither.

Yeah but could I be a real lumberjack there?

ShayP

Quote from: GravitySucks on April 29, 2018, 11:37:25 AM
Fuckin A right peckerhead and don’t you go forgettin it neither.

I don't think I've ever been called a peckerhead before.  Thanks for making this memorable.

SredniVashtar

Quote from: GravitySucks on April 29, 2018, 11:37:25 AM
Fuckin A right peckerhead and don’t you go forgettin it neither.

Just because you live in Texas doesn't make you a Texan, you transplanted Chicagoan.

Not going well.  Can't turn the set screws  @%$#@&^

Dr. MD MD

Quote from: Walks_At_Night on April 29, 2018, 11:46:06 AM
Not going well.  Can't turn the set screws  @%$#@&^

Did you strip them already?!

GravitySucks

Quote from: SredniVashtar on April 29, 2018, 11:40:55 AM
Just because you live in Texas doesn't make you a Texan, you transplanted Chicagoan.

I can rope your ass and hog tie you for SV any time the two of you are ready.

GravitySucks

Quote from: Walks_At_Night on April 29, 2018, 11:46:06 AM
Not going well.  Can't turn the set screws  @%$#@&^

Liquid wrench. Are the sunken hex screws?

I think mine were like 1/4” bolts with square heads. Don’t remember. The door is on my building up at the woods.

Jojo

Quote from: Dr. MD MD on April 29, 2018, 11:54:05 AM
Did you strip them already?!
I suppose you know holding pliers or a wrench tight and straight up (or very flat) and on the screws might bet them started.  If you wedge a tight, tiny piece of duct tape under and over the screw, sometimes that gives you enough of surface to tug to start the screw turning with pliers.

Left loosie, when facing them, lol.

Smaller screwdriver to start them?

One time I had luck after icing the screw (and drying it).

Quote from: GravitySucks on April 29, 2018, 11:59:02 AM
Liquid wrench. Are the sunken hex screws?

Indeed - liquid wrench is our friend in the Garage and no I didn't strip the screws.  Had to move
up from my little open ended 3/8" wrench to my Father's old school stuff.  Leverage is also our friend
in the Garage.

Got one side done.  Took a lot more strength than that skinny old boy in the video exhibited. 
Christ that wasn't easy.

Next problem is I'm looped from the damn liquid wrench fumes.   How does Aldous function?

GravitySucks

Quote from: Walks_At_Night on April 29, 2018, 12:07:43 PM
Indeed - liquid wrench is our friend in the Garage and no I didn't strip the screws.  Had to move
up from my little open ended 3/8" wrench to my Father's old school stuff.  Leverage is also our friend
in the Garage.

Got one side done.  Took a lot more strength than that skinny old boy in the video exhibited. 
Christ that wasn't easy.

Next problem is I'm looped from the damn liquid wrench fumes.   How does Aldous function?

Practice

Quote from: Jojo on April 29, 2018, 12:01:48 PM
I suppose you know holding pliers or a wrench tight and straight up (or very flat) and on the screws might bet them started.  If you wedge a tight, tiny piece of duct tape under and over the screw, sometimes that gives you enough of surface to tug to start the screw turning with pliers.

Left loosie, when facing them, lol.

Smaller screwdriver to start them?

One time I had luck after icing the screw (and drying it).

Thanks JoJo - solid advice but this a bit of special situation..........


Mission accomplished. 

Garage Door balanced and lubricated, opener is purring like Orangey Cat  with a bonus of me not ending up in the ER..........

GravitySucks

Quote from: Walks_At_Night on April 29, 2018, 01:21:06 PM
Mission accomplished. 

Garage Door balanced and lubricated, opener is purring like Orangey Cat  with a bonus of me not ending up in the ER..........

Good deal


Jojo

Quote from: Walks_At_Night on April 29, 2018, 01:21:06 PM
Mission accomplished. 

Garage Door balanced and lubricated, opener is purring like Orangey Cat  with a bonus of me not ending up in the ER..........
Congratulations!

Powered by SMFPacks Menu Editor Mod